[<< wikibooks] MATLAB Programming/Bode Plot
== Introduction ==
This article is on the topic of creating Bode plots in MATLAB. The quick answer is use the bode command. However, the bode command has several options and the plots generated by the bode command are not easily reformatted. The default formatting of most MATLAB plots is good for analysis but less than ideal for dropping into Word and PowerPoint documents or even this website. As a result this article presents an alternative that requires more lines of code but offers the full formatting flexibility of the generic plot command.


== MATLAB's Bode Command ==
The basic bode command is as follows

>> bode(LTI_SYS)

where

LTI_SYS is an LTI object - TF, SS, ZPK, or FRDThe bode command will automatically call gcf which will put the bode plot on the current figure. If no figure exists then one is created by gcf.
If you wish to specify the frequency points at which LTI_SYS is plotted then create a frequency vector using logspace or linspace as follows

>> freqVec = logspace(-1, 3, 5000);
>> bode(LTI_SYS, freqVec * (2*pi))

where

freqVec is a vector of 5000 frequencies, in Hz, spaced evenly on a log scale from 10-1 to 103
pi is a MATLAB constant equal to the value of 
  
    
      
        π
      
    
    {\displaystyle \pi }
   and in this case it is used to convert freqVec to rad/sec as it is passed to the bode commandIn order to get the magnitude and phase at each frequency point the bode command must be called with output arguments such as

>> [mag, phase] = bode(LTI_SYS);

or

>> [mag, phase] = bode(LTI_SYS, freqVec * (2*pi));

where

mag is the magnitude (not in dB) at each point in freqVec
phase is the phase (in degrees) at each point in freqVecThe mag and phase variables must come out as 3D arrays. Assuming LTI_SYS is SISO then the commands below will convert mag and phase into the vectors you would expect

>> mag = mag(:);
>> phase = phase(:);
>> mag = db(mag);                % to get the magnitude in 20log dB


=== Issues with the bode command ===
The main issue with the bode command is reformatting of the plot. The bode command appears to use a normal semilogx plot and then apply patches ro something similar to the figure. This can lead to odd behavior when attempting to create multi-line titles, reformat line widths or font sizes, etc. The normal relationship of axes to figure is just not quite present.


== External Links ==
More on Bode plots at ControlTheoryPro.com